Tajima DG by Pulse Community - DG/ML General Discussion - Thread Trim - Messages https://dgcommunity.pulsemicro.com/topic163-thread-trim.aspx Tajima DG by Pulse Community - DG/ML General Discussion - Thread Trim - Messages en-us http://blogs.law.harvard.edu/tech/rss Jitbit AspNetForum Tue, 08 Aug 2017 19:29:11 GMT Tue, 08 Aug 2017 19:29:11 GMT https://dgcommunity.pulsemicro.com/topic163-thread-trim.aspx Message from Tajima Software Tue, 08 Aug 2017 19:29:11 GMT https://dgcommunity.pulsemicro.com/topic163-thread-trim.aspx Message from nogogolfshop Tue, 08 Aug 2017 16:42:12 GMT https://dgcommunity.pulsemicro.com/topic163-thread-trim.aspx Message from Tajima Software Eric Rewerts wrote:
Hello,

I have been having issues with my thread trimming on a TMBR unit. When moving to a new color the knife is missing the cut about 50% of the time and then pulls the thread so tight the bobbin thread shows through. I have to babysit the machine the entire time so that I can stop it to manually cut the thread. Any suggestions on a fix?



Hello nogogolfshop,

When you say that the knife is missing the cut, do you mean that the trim command in your design is not happening? Or that the knife is physically missing the thread when a trim command is issued?

If it is the latter, then it sounds like it may be a machine issue and we'd recommend that you contact your Tajima distributor to troubleshoot and hopefully fix the issue.]]> Tue, 08 Aug 2017 16:12:17 GMT https://dgcommunity.pulsemicro.com/topic163-thread-trim.aspx Message from nogogolfshop
I have been having issues with my thread trimming on a TMBR unit. When moving to a new color the knife is missing the cut about 50% of the time and then pulls the thread so tight the bobbin thread shows through. I have to babysit the machine the entire time so that I can stop it to manually cut the thread. Any suggestions on a fix?]]> Sun, 06 Aug 2017 18:58:05 GMT