HomeTechnical Assistance

Get assistance from your peers with any PulseCloud issues you may be experiencing

overlap in complex fill Messages in this topic - RSS

mac ryan
mac ryan
Posts: 12


2/5/2024
mac ryan
mac ryan
Posts: 12
pulse 15.1.73.6300 maestro..
in sequence view nr 10, once complex fill , density profile/ anlonge middle, you ca adjust overlap linesin quality control. but the lines don't look fine in 3D view, also in embroiderie.
when density profile/ along edge inside 0.6 the lines dissappaers but the overlap is also gone.I can't change this because overlap is light gray.How tto change this.
see file mentl2 and meltl2test.pxf

0 link
Tajima Software
Tajima Software
Administrator
Posts: 470


2/6/2024
Tajima Software
Tajima Software
Administrator
Posts: 470
Please see the reply from our support team:

If we are talking about a complex fill with crossing stitch angles, then it could be done by copy/pasting the shape and fill each one of the complex fill segments in opposing angles.
Make sure that the Start and End beads are positioned correctly so that the stitches travel according to your expectations.
In case you want the very first stitches to start in the middle, then you an insert Run stitches in the desired position.
+1 link






Powered by Jitbit Forum 8.3.7.0 © 2006-2013 Jitbit Software