Talk about anything related to Tajima DG16 by Pulse here
Way to tuck stitches under, in the same segment?
|
MrLogoSD Posts: 12
5/14/2026
|
The triangle in the center of the 'e'. I'm trying to have it tuck under so I can go to the next segment left of it. I want the end code to be where it's at, to avoid trimming. (It's for a cap, following the bottom-to-top, center-outwards method). It's usually fine when ending at the tip/end of the 'e'. I've tried moving the start and stop symbols and the only way is to stop too far from the closest jump area.
|
|
|
0
link
|
|
MrLogoSD Posts: 12
5/14/2026
|
I guess the only way to do it without some feature in the software is to break the letter itself into segments.
|
|
|
0
link
|
|
MrLogoSD Posts: 12
10 days ago
|
MrLogoSD wrote:
I guess the only way to do it without some feature in the software is to break the letter itself into segments.
Marking as complete
|
|
|
0
link
|
|
Luebbers Posts: 22
1 days ago
|
Hi MrLogoSD, what you want to do is to not have that tab there at all. You want to extend the other part of the e so that it goes under the part where you currently have that tab. Then also move your start point to that section.
|
|
|
0
link
|