HomeDG/ML General Discussion

Discuss anything related to Tajima DG/ML14 by Pulse or earlier versions here

Trimming problems Messages in this topic - RSS

wwshirts
wwshirts
Posts: 1


11/23/2015
wwshirts
wwshirts
Posts: 1
I am struggling! When I go to put my .dst or .tbf on a usb to load onto the machine, it gets rid of all of my trim commands! For the life of me, I can't figure out how to prevent this. Has anyone else had this problem?
0 link
isilay
isilay
Posts: 58


11/24/2015
isilay
isilay
Posts: 58
It can be because of your embroidery machine's "Jump Convert" setting. Tajima's default value is 3J (3 jumps). If the machine setting is adjusted to a higher value, then the trims may not be performed.
+1 link






Powered by Jitbit Forum 8.3.7.0 © 2006-2013 Jitbit Software